ANET A8 I3 Ender MOSFET Board Upgrade 3D Printer Heated Bed Power Module

Description

Little Monster Heated Bed Power Expansion Module
-
1800 Watt Upgrade
The Little Monster is a premium DC heater control board that can drive up to 60 Amps.  Most heated beds don't need that much current... However,  this guy has such a low on resistance that you gain a significant amount of efficiency.  Less power wasted means more power to your heated bed or hot end.
The Little Monster is controlled by an existing heated bed output.  Remove the headed bed from you main board.  Connect it to there Little Monster Terminals.  Then run the control wire from where the heated  WAS connected to the green connectors.  Connect a power supply to the Mosterfet.  It does not even have to be the supply running the printer.
Our wiring kit is ideally suited to install the Little Monster in many of the FDM printers on the market today.  Both products together provide the user with an easy installation and provide optimal operation.
All of Digital Sqrt's products are open source and manufactured in the USA.
We also manufacture a 2 channel version. (https://www.ebay.com/itm/254727143701)
Little Monster Power Module features:
Upgrade any 3D printer control board
Drives up to 60Amps continuously (24-7), Not a peak value.
.002 Ohms of resistance (or less) when the MOSFET is on
Max 1800 Watt delivery to any inductive or non-inductive load
Runs on 12v-30v
Uses existing output as control
Air flow through heat sink.  Better cooling...Not that you will need it.
Optically Isolated (Printer Control Board and Heated bed can have different power supplies)
Opensource Hardware design
Same mounting hole pattern as other mosfet boards
Unpolarized control lines.  Just plug it into your Heated bed output,  The +/- no longer matter.  You can't wire it wrong!
Wiring Kit features:
This is everything you need to install the Little Monster Power
Module
in your printer.
12 AWG wire
6 ring terminals (2 for heated bed, 2 for board power, + 2 more for your power supply connections)
Heat shrink to cover exposed connections  (4 Black for power, 2 white for heated bed)
Little Driver Power Module
Package contents:
Little Monster Heated Bed Power Module
Control cable for input signal (27.5in long) our competitors only give you a cable about 6in long
Wiring Kit
p
ackage contents:
5 feet of 12AWG Wire (2.5 feet of two different colors, Red and Black)
6 30AMP ring terminals
6 pieces of heat shrink (4 black, 2 white)